Backup CPU address same as primary CPU
I am getting a error in RNRP fault tracer (option 1) that "Backup CPU address is same as Primary CPU". I am not able to ping backup CPU also. Status in hardware configuration shows "Redundant mode enabled. Unit B acts primary."
Controller log shows error message as "failed to send to backup socket" continuously.
IP address of Primary CPU is 172.16.4.161.
1. Assigned the IP address for the Primary Controller. Then set the backup IP address in the Ip Config Tool.
Refer attached file
2. For Secondary controller only assign the IP address. No need to give once again the backup IP address for the controller.
Note:-From the IPConfig Tool Help(attached help)
Hope this will answer your query..please try this..
Remove the power or battery of backup cpu .
1 . Set the ip for Primary CPU & & also configure backup cpu ip via SETTINGS tab.
2. now connect power to backup cpu & wait for dual LED which shows both are synchronised.
3. check for RNRP. Check whether system error or any other error.