Communicate AC800F signals through modbus TCP

Hello,

I need to communicate an AC800F with an RTU through ModBus TCP but I'm not sure if that's possible with the actual system. I have an AC800F with an EI 803F module connected to a switch where the RTU is also connected. Can you please help me? Is it possible to configure the AC800F to transmit using ModBus?

Thanks in advance for your help.

Comments (0) New comment

rc0ntreras Rank: 2688

Asked 6 years ago

Answer this question Follow

Voted best answer

Hi, you need freelance version 2013 for modbus TCP support

Comments (1) New comment

Govindaraj AKS expert

Rank: 11

Answered 6 years ago

Answers

buy one TCP / RTU convertor, this is the easiest way to complete your job.

Comments (1) New comment

Awesomedays Rank: 151

Answered 6 years ago

Hi,

Please note in Freelance 2013 SP1 AC 800F supports Modbus TCP, So in that version it's straight forward communicate with rtu over modbus tcp. if you have version lower than F2013 SP1 then as suggested in second answer use converter rtu/tcp. note that in AC 800F you need card CI820F and TB 870 with cable TK821.

Hope that helps...

Comments (7) New comment

by rc0ntreras Rank: 2688 on 1/27/2015 6:11:04 AM | Like (0) | Report

Thanks ... Is it possible to update the version I have without the need of a new license?

by Sumit Gargav AKS expert

Rank: 3 on 1/27/2015 9:46:07 PM | Like (0) | Report

If you are with version lower then 2013 then you need new license. for upgrade of sw/license cost effective way is go with automation sentinel

by Sumit Gargav AKS expert

Rank: 3 on 1/27/2015 9:47:36 PM | Like (0) | Report

Also would like to add If you are installing new version on new PC where there is no parallel port then you need to buy new usb(hardware key)

by moji Rank: 150 on 10/16/2016 8:37:21 AM | Like (0) | Report

In AC800F,which card soppurt modbus tcp??as I know built in ethernet port of AC900F ,support modbus tcp.

by Sumit Gargav AKS expert

Rank: 3 on 10/16/2016 5:45:10 PM | Like (0) | Report

If AC 800F is with Freelance 2013 SP1 firmware and greater version then Ethernet cards starting with EI 801/02/03/11/12/13 can support Modbus TCP on AC 800F. I guess even FF card FI 840F can also support Modbus TCP.

by moji Rank: 150 on 10/16/2016 10:34:13 PM | Like (0) | Report

thanks dear Sumit

by Sumit Gargav AKS expert

Rank: 3 on 10/17/2016 12:38:56 AM | Like (0) | Report

you are welcome :)

Add new comment

Sumit Gargav AKS expert

Rank: 3

Answered 6 years ago

Source:

Question details

Communicate AC800F signals through modbus TCP

Voted best answer

Answers

Other questions needing answers

Related topics

AKS experts