Communication between AC500 v2 ( PM583-ETH ) and Panel 800 ( pp886h) using ethernet
Hello all ,
i'm new to this ABB PLC
i'm using pm583-eth and pp886h HMI. i want to communicate them using ethernet
can anybody explain how to do the communication.
Control & Automation Engineer
Voted best answer
I suppose you want to use Modbus TCP/IP communication, because ethernet is just a media (line) to transfer data using some protocol.
Looking in available drivers in Panel 800 ver. 6, most probably the suitable driver for Modbus TCP/IP for AC500 will be
MODBUS Master ASCII/RTU/TCP
The other possible driver is
ABB Modbus AC500
but I suppose that is a serial communication, which is also possible for pm583 using COM port.
Look in the manuals for these driver's details.