problem in communication using CI858 and ACS800 engineering drive
In this project I am using ACS600 and ACS800 drive. With the help of your manual, I have run ACS600 drive without any problem but when I go for run ACS800 drive through PLC so there is COM MODUE (7510) fault appears on drive. And when I reset it its move. But again I give run command to the drive this fault again come. for testing my drive parameters and communication cable is this ok or not, I have connected direct to the CPU and make confiduration in plc program in module bus so its running without any fault. But when I connect to CI858 it goes to fault. Finally I am unable to make communication between ACS800 and CI8585 but same configuration with ACS600 working properly.