Error in PM573-ETH
Whenever i download program i get the following error-
"The last online services has not been executed correctly! Service number: 63 Error number: 40"
this error occurs once out of 2 to 3 times i redownload my program, due to his my program gets cleaned.
is there a solution to avoid this error so that my retain data to be saved without program getting cleaned all.
Some suggestions are as below,
1) For verification, increase cycle time by 100ms
2) Perform a clean all followed by rebuild all procedure>Download the program>Create boot project>In PLC browser execute command diagreset>Execute command reboot>After reboot, PLC should go to Run mode
Observe whether issue re-occurs.