Move Instruction in Control Builder F
Is there move instruction in CBF??
I mean move as a result for condition such as move variable value at certain time from source variable to destination variable and when the condition disappears the value of destination will not depend on the source Value, Direct connection between variables in CBF means that the two variables are always equal.
Voted best answer
In ST you can achieve move using if_else check example below
IF ConditionV = 1 THEN
DestinationV := SourceV ;
DestinationV := i;
END_PROGRAM, Not sure is it something you are looking for...
Whereas in fbd you can use same binary select as replied in previous question.
I can say that freelance default blocks and instructions are so rich that you can perform anything and everything you want, just need to explore.