Compact control builder project 5.0.2/4 not opening
I have compact control builder version 5.1.0 installed. While opening a Compact Control Builder project which was created from CBM version 5.0.2/4, I am not being able to open the project and getting warnings as BasicHWLib not found and similar library related warnings. At last could not open the project with error "Opening Project Failed".
Can anyone help in the subjected matter ?
Its commonly observed.
if you want to upgrade this project, first add the hardware library of CB5.0.2 in your current hardware library.....
then try to upgrade, your problem is resolved.
or u mail your backup on below mentioned link:
I will upgrade it and send back to you ASAP.
You have compact control builder 5.1.0 & you are trying to upgrade it from the compact backup which you were created in 800xA Control Builder M version 5.0.2/4.
This is not possible to upgrade the project in defferent angle like you can upgrade the compact control builder from compact control builder 4.1 and 5.0.2 projects to a CCB 5.1 project version
It is not possible to upgrade a project created in Control Builder Professional to
Compact Control Builder 5.1.
Please refer the manual in page no 137 onwards before you start the upgradation http://abblibrary.abb.com/global/scot/scot354.nsf/veritydisplay/268477ba4672dfb