Freelance 2016 - Not defined diagnostic
I'm trying to figure out what is wrong with CI840 slave device.
I've got configuration like redundant 902F, CI930 for profibus master. There are 2 slaves on one line - redundant CI840 (redundancy works ok). First slave was configured with .gsd, second via DTM. In commisioning mode I see on CI840 on unit diagnostic tab statement like this: "Not defined diagnostic (Start bit 24, End bit 24, value 1)" - I've got 10 simillar messages for it (for this node there is 10 modules ,configured by .GSD); for second slave I've got simillar messages but only 5 (here is 9 modules, configured by DTM).
Additionally in DigiVis I recieve message "Diagnosis fault for unit"
Actual firmware for CI840 is 4.1/3
Where to find any clue?
This question has not yet been answered.