ACS580 "CHECK CONNECTION" problem
ACS580 drive. R10 module.
Powered the drive. Took ID run of motor. But on next power recycle it shows "Check connection".
Had some doubts. Checked and changed
1. Cable between CDP and control board.
But problem not solved. In drive composer entry it shows "No drive found". Where i charged the motor by this DRIVE for 2 hours before this issues.
Need some help.
in addition to the connection between the panel and the control board, in the R10 version it may be possible to control the connection between the drive and the control board.
IMHO the drive composer response justify that the control board is not correct connected to the drive. To exclude other issue, you can try to give 24VDC to pin 40 - 41 - external 24 VDC without power in input of drive. The control board and the panel
should answer you correctly and you should be able to connect the drive composer SW.
Hope this help you, let us know about the results