Freelance DCS Faceplates have View Selection Area disabled
I'm using FreeLance 2016 SP1 demo. For unknown reasons, when i run FreeLance Operations demo, all faceplate (of standard FB and user FB) have View Selection Area ( Bottom area with 3 buttons) disabled. Is this because my FreeLance license is trial? How to enable it?
Asked 2 years ago
Voted best answer
1
Hi TruongND,
The View Selection Area was removed in version 2016 of Freelance. It was never used, as all Freelance faceplates have only one view, so the R&D decided to remove it. See this snippet from Release document for v2016:
Hope this clears things out.
Best Regards,
Mike
Source: 2PAA115225R0001_-_en_Freelance_2016_Release
Answers
0
You can compare the manuals and you will find that the look of the displayes has changed. It was also just look and feel.
Answered 2 years ago
0
This is an image of faceplate in T568 FreeLance 800F System Engineering RevC, a training document that I have. The bottom area of faceplate has 3 buttons.
Answered 2 years ago
by JuergenV Rank: 73 on 9/21/2017 12:51:04 AM | Like (0) | Report
The demo version has no such restrictions. What is your operating system?
Best regards
Jürgen
Add new comment