800xA TapCC Control Module (Control Standard Lib)
I hava an analog signal input (Real IO).
(Real IO connected to a block whose output is CC)-----> TapCC
Other than the Output, TapCC has 2 other outputs; One is Tap (Just a Tapped Signal) and other is "OutBack"
Now I want to use this "OutBack"
My Intention of using "OutBack" is whenever the input signal has a channel failure, "OutBack" should hold the last good value.
But actually i could not see this. Infact i do not find any difference between "OutBack" & "Tap".
What is the exact difference between "Tap" & "OutBack"?
How to use "OutBack"?
This question has not yet been answered.